We use own and third party cookies, for the analysis of user navigation. If you continue browsing, we consider that you accept their use. You can change the settings or get more information here.

ALU Heatbed MK3

-54% ALU Heatbed MK3

All features similar to MK2, you can also operate this board with 12 Volt or 24 Volt 

  • Heatbed with 3mm aluminum core. You can print directly on the heatbed, the glass is recommended but not mandatory 
  • The metallic side is the top print side and the black side is the bottom side. We recommend insulating the bottom side with Thermal Insulator
  • Dual power supply. Operate at 12 Volt or 24 Volt (you can use thinner wires when operating at 24 Volt)
  • A central mounting hole on the front side to allow for three point mounting
  • Large solder pads
  • Dimensions 214mm x 214mm (same as MK2)
  • 1 layer 35μm copper
  • Maximum temperature rating: 180ºC

Write a review

Note: HTML is not translated!
    Bad           Good

  • Views: 7702
  • Product Code: Mk3
  • Availability: In Stock
  • 25.99€
  • 12.00€
  • Ex Tax: 9.92€

Tags: Heated Bed, Electronic,

Check out this bundle
Includes a mk3 hot bed, borosilicate tempered glass, thermal insulation, a wired thermistor with connector, and kapton tape. The fundamental component..