P3steel Printed Parts

-37% P3steel Printed Parts




    Body, ildler and budas adaptor 

    The extruder included in this kit is based on the popular Greg’s Wade, and it has been redesigned to fit to the Prusa i3 and its variants. 

  • It takes up less space in X axis so it can’t collide with the rods when moving to the edges. 

  • It also has a more stable junction to the cart, as it fits in 4 points and for M4 screws. 

  • Greater simplicity of use and maintenance, as it is accessed to change the filament from the front. 

  • Center gravity is better positioned, which prodeuces fewer oscillations. 


These gears are slightly smaller in order not to rub with x-carriage. In addition, the holes are wider to allow an easier mounting. 

-X Axis:

Motor End and Idler End:

The Motor End has a hole to put a screw in order to calibrate Z axis more easily.

The Idler End has a tensioner in order to avoid that the belt gets loose.


This carriage uses four bearings LM8UU and it supports GT2 belts.

It has a grimace that fits to the regualr sized gears.


Belt holder

Spacer plates of motor axis

-Other Parts:

Endstop clamps and holders (we include two type to provide more compatibility)


This pulleys are printed in one piece and they fit to bearings 623zz (we recommend to use two bearing for each pulley)

You can choose the colour, otherwise, we will ship them in any available colour.

Write a review

Note: HTML is not translated!
    Bad           Good


All our kits are printed with high quality materials, producing very strong and durable parts.

  • Dimensional:

The gears are completely round and the teeth fit deeply.

  • ​Infill:

​All pieces have an approximately infill of 40% plus a minimum perimeter of 1 mm (lower, upper and sides).

  • Superficial:

All parts are inspected after being printed in order to look for flaws. They have, as it is natural, the characteristics of the 3D printing process.


Custom products

This product is prepared according to the customer requirements, thus, the handling time is between 24 and 72 hours approximately.

  • Views: 7903
  • Brand: HTA3D
  • Product Code: P3steel Printed Parts
  • Availability: In Stock
  • 24.00€
  • 15.00€
  • Ex Tax: 12.40€

Available Options

Tags: Printed Parts, Components,

Check out this bundle
Include the printed parts, bearings, couplers, hobbed bolt, special screws, belts and pulleys of this popular design:http://reprap.org/wiki/P3Steel/..
Hobbed Bolt
Hobbed Bolt
GT2 Pulley - 20T
608zz Bearing
608zz Bearing
623zz Bearing
623zz Bearing
Bundle price: 35.79€
You save 1.88€!

Add bundle to Cart