P3steel Printed Parts + Movement Kit + Special Hardware Set
KIT P3STEEL PRINTED PARTS WITH MOVEMENT AND SPECIAL HARDWARE SET
Based on: http://reprap.org/wiki/P3Steel
This kit contains:
-All Printed parts that you will need to build your P3Steel 3D printer
-All Bearings, belts, pulleys and flexible couplings that you will need to build your P3Steel 3D printer
-The Special hardware you'll need for this project and that hardly find in hardware stores or unspecialized shops
Body, ildler and budas adaptor
The extruder included in this kit is base don the popular Greg’s Wade, and it has been redesigned to fit to the Prusa i3 and its variants.
It takes up less space in X axis so it can’t collide with the rods when moving to the edges.
It also has a more stable junction to the cart, as it fits in 4 points and for M4 screws.
Greater simplicity of use and maintenance, as it is accessed to change the filament from the front.
Center gravity is better positioned, which prodeuces fewer oscillations.
These gears are slightly smaller in order not to rub with x-carriage. In addition, the holes are wider to allow an easier mounting.
Motor End and Idler End:
The Motor End has a hole to put a screw in order to calibrate Z axis more easily.
The Idler End has a tensioner in order to avoid that the belt gets loose.
This carriage uses four bearings LM8UU and it supports GT2 belts.
It has a grimace that fits to the
regualr sized gears.
Spacer plates of motor axis
Endstop clamps and holders (we include two type to provide more compatibility)
This pulleys are printed in one piece and they fit to bearings 623zz (we recommend to use two bearing for each pulley)
You can choose the colour, otherwise, we will ship them in any available colour.
P3steel Movement Kit:
-12x LM8UU linear bearing
-4x 608zz Angular Bearings
-4x 623zz Angular Bearing
-2x 5x5mm Coupler shaft
-2m GT2 Belt, Made of neoprene, fiberglass reinforced
-2x 20 teeth aluminium timing pulley
Special Hardware Set Kit:
- 2x M3x40 Partially treated bolts with springs:
- M8x20 setscrew for extruder idler:
- M3x10 setscrew small gear:
-2x M5 Black / White nylon nut for Z axis movement, great improvement. Nylon has an excelent abrasion resistance, also provides a more soft and reliable z movement.
You can buy one of our Hotends, with discount for this kit.
All our kits are printed with high quality materials, producing very strong and durable parts.
The gears are completely round and the teeth fit deeply.
All pieces have an approximately infill of 40% plus a minimum perimeter of 1 mm (lower, upper and sides).
All parts are inspected after being printed in order to look for flaws. They have, as it is natural, the characteristics of the 3D printing process.