Menu
Tu Carro
HTA3D

Opiniones de nuestros clientes

Consulta las valoraciones de productos publicadas por nuestros clientes.

Puntuación media 4,9/5 5.694 Valoraciones aprobadas
5 estrellas 5.176 (90.9%) 4 estrellas 391 (6.9%) 3 estrellas 56 (1%) 2 estrellas 31 (0.5%) 1 estrella 40 (0.7%)

Mostrando 41–56 de 56 valoraciones

Carsten Jonkers

TLDR: Might be ok, but I would advice an external MOSFET board

Does not always keep up with the current going through the MOSFET for the heated bed, causing it to melt. Happened to two boards, one of which was my own fault, but for the second I followed the advice of the Tech support, which always replied in a day, and it still wasn't enough to prevent the melting of the MOSFET. I have however already been offered a replacement for the second board, how this will work out, time will tell.

But if you are going with this board, which is pretty good, then I would seriously advice to pick up an external MOSFET board which is able to deal with a higher current and relieve the MOSFET on this RAMPS 1.5. I've been told this can also be prevented by using the RAMPS 1.4 SB sold on this site instead, but I cannot confirm this yet seeing that I don't own that RAMPS yet.

Imagen de RAMPS 1.5 para Arduino Mega 2560 — shield modular RepRap
RAMPS 1.5 para Arduino Mega 2560 — shield modular RepRap Opinión del Cliente Ver producto
David Nieto Hernández

No estoy muy contento con estos "rodamientos", ya que al fijarlo en su alojamiento, donde se ejercen cierta presión sobre sus laterales se deforman, por lo que no consiguen el objetivo buscado de un rodamiento, que es deslizar suavemente, vamos que me hubiera salido igual hacer un cilindro con un diametro interior de 8mm. Creo que en próximos dias os compraré unos rodamientos Lm8uu. En conclusión, producto no recomendable.

Imagen de Casquillo lineal Igus DryLin RJ4JP-01-08 para eje de 8 mm — formato LM8UU
Casquillo lineal Igus DryLin RJ4JP-01-08 para eje de 8 mm — formato LM8UU Opinión del Cliente Ver producto