In this pages you can find the ratings that customers make about our products, you can get useful information from the experience of other users, ideas and tips.
El cable Dupont 3P que lo voy a usar para alargar los finales de carrera viene con los colores que no coinciden con los de el cable del final de carrera mecánico.
El final de carrera viene ordenados: Rojo, positivo. Negro, negativo y verde, contacto.
El cable que me han suministrado viene rojo, verde, negro. esto puede generar una confusión al conectarlas al RAMP 1.5 con el riesgo de provocar un corto..
A mi no me afecta, porque suelo desarmar los cables para trenzarlos para disminuir interferencias, y los vuelvo a montar correctamente, pero creo que es interesante avisárselo..
Los pines y conexiones de la placa estaban ligeramente desviados, nos ha supuesto un problema para el conexionado de los controladores de motor; pero por otro lado funcionaba con bastante normalidad.
TLDR: Might be ok, but I would advice an external MOSFET board
Does not always keep up with the current going through the MOSFET for the heated bed, causing it to melt. Happened to two boards, one of which was my own fault, but for the second I followed the advice of the Tech support, which always replied in a day, and it still wasn't enough to prevent the melting of the MOSFET. I have however already been offered a replacement for the second board, how this will work out, time will tell.
But if you are going with this board, which is pretty good, then I would seriously advice to pick up an external MOSFET board which is able to deal with a higher current and relieve the MOSFET on this RAMPS 1.5. I've been told this can also be prevented by using the RAMPS 1.4 SB sold on this site instead, but I cannot confirm this yet seeing that I don't own that RAMPS yet.
