Power supply accessories

It is a tinned copper 12 AWG cable resistant to high temperatures. With silicone protection, it is very flexible.Length: 1 meterSection: 3.31mm²Diameter: 2.25mmColour: black..

It is a tinned copper 12 AWG cable resistant to high temperatures. With silicone protection, it is very flexible.Length: 1 meterSection: 3.31mm²Diameter: 2.25mmColour: red..

Red and black wires to power the RAMPS from the power supply.It is a tinned copper cable resistant to high temperatures. With silicone protection, it is very flexible.One of the ends is welded to facilitate the introduction of the cable into the RAMPS connector.Length: 70cmSection: 3.31mm²Diameter: ..

It is a tinned copper 16 AWG cable resistant to high temperatures. With silicone protection, it is very flexible.Length: 1mCable diameter: 1.53mmOuter diameter: 3mmColour: negro..

It is a tinned copper 16 AWG cable resistant to high temperatures. With silicone protection, it is very flexible.Length: 1mCable diameter: 1.53mmOuter diameter: 3mmColour: red..

Red and black wires for the heated bed. Red and black cables for the heated bed. One end of each cable has a connector crimped for the connection to the Ramps.This cable is used in our 3DSteel and P3Steel, it is also compatible with other 3D printer models of similar format.It is a tinned copper cab..

Printed protective part for the 33A power supply used by the 3DSteel printer.You can make the connections of the power supply and then place the printed pieces. Thanks to its design it is very easy to assemble and manipulate afterwards.It is designed to use the power outlet with switch, so that it w..

3 wiresConector 1 : Schuko 250v 10AConector 2: IEC 60320 C13Max Voltage: 250V Max Power: 2500W ..

Power socket with switch. You can directly connect the power cable (IEC 60320 C13) without the need of welding, with the convenience of being able to connect and disconnect it at any time to facilitate transport, for example. To make the connection of the switch, it is not necessary to use welds if ..

Uninterruptible Power Supply Module with shutdown sensor for 24V printers.Contains LM393 voltage comparator chip, which can detect power outages.Logic voltage: 3.3V or 5VInput voltage: DC24VCapacitors: 9Size: 55.53x50mm1 unit..