- Stock: 121
- Model: FCMMini-XH2.54-Vertical
Model:
Mechanical 70cm cable
Mechanical with wheel 70cm cable
Mechanical with wheel 1m cable
Mini Mechanic XH2.54 Horizontal
Mini Mechanic XH2.54 Vertical
Optical 50cm cable
Compact Optical 1m cable
Mechanical KW11
Mechanical KW12-3
Mechanical D2F-5L - Omron
Mini mechanical endstop with vertical connector, metal lever, LED indicator and an approximately 1 m cable. Its perpendicular cable exit can simplify wiring where there is little clearance beside the PCB edge.
Features and dimensions
- Lever-operated mechanical microswitch.
- XH2.54 connector arranged vertically, perpendicular to the PCB.
- Integrated LED indicator.
- Approximately 1 m cable.
- 27 × 13 mm PCB with 20 mm mounting centres, according to the available drawing.
Wiring and commissioning
This module includes indicator electronics and must be connected using supply, GND and signal. Before applying power, identify the controller pin order and verify that it matches the cable. Do not assign functions by wire colour.
- Marlin: enable the correct endstop input, set its hit state and test with
M119. - Klipper: enter the board-specific GPIO in
endstop_pinand validate withQUERY_ENDSTOPS. Add!only if the reading is reversed. - RepRapFirmware 3: use
M574with typeS1, the correct axis end and input pin; invert the pin with!when confirmed by testing.
Compatibility
Compatibility depends on dimensions, bracket, travel, vertical cable exit, logic voltage and pinout. Where a cable exit parallel to the PCB is needed, choose the horizontal mini mechanical endstop.
Package contents
One vertical mini module and one approximately 1 m cable. Bracket and mounting hardware are not included.
