Menu
Your Cart

POWGE 1.5GT 26T toothed idler for 6 mm belt, 5 mm bore

POWGE 1.5GT 26T toothed idler for 6 mm belt, 5 mm bore
POWGE 1.5GT 26T toothed idler for 6 mm belt, 5 mm bore
POWGE 1.5GT 26T toothed idler for 6 mm belt, 5 mm bore
New
POWGE 1.5GT 26T toothed idler for 6 mm belt, 5 mm bore
POWGE 1.5GT 26T toothed idler for 6 mm belt, 5 mm bore
POWGE 1.5GT 26T toothed idler for 6 mm belt, 5 mm bore
POWGE 1.5GT 26T toothed idler for 6 mm belt, 5 mm bore
4.50€
Ex Tax: 3.72€
  • Stock: 25
  • Model: POWGE-15GT-I26-6-5
Fast shipping from Spain
Delivery from 24 hours and free shipping available in mainland Spain.
Stock on hand
Shipped quickly from Spain, with a full VAT invoice.
Secure & flexible payment
Pay by card, PayPal or bank transfer.
Expert technical support
Over 10 years helping customers with components and compatibility.

POWGE 1.5GT 26T toothed idler for 6 mm belt, 5 mm bore. Guides the toothed side.

Features and dimensions

  • 1.5GT profile, 1.5 mm pitch.
  • 26 teeth.
  • For 6 mm belts; 5 mm bore.
  • From the POWGE variant drawing: 9 mm overall; 7 mm toothed width; 18 mm flanges.
  • Toothed outside diameter per the drawing: 12.15 ± 0.05 mm.

Compatibility and installation

Clamp the inner bearing race without trapping the rotating body. Centre the running surface with spacers and check that the pulley spins freely before tensioning.

Use it where the toothed side runs against the pulley. It does not replace a drive pulley or a smooth back-side idler.

Do not mix belts and toothed pulleys of different pitches. When converting from GT2 to 1.5GT, replace all mating toothed parts, check height, shaft, flanges, routing and anchors, and recalculate travel. Keep a smooth idler only if its running surface and mounting dimensions suit the new setup.

Contents: one pulley.

Depending on the production batch, the aluminium body may or may not carry the POWGE engraving.

Choose this if…

You need to guide the toothed side of a 6 mm 1.5GT belt on a 5 mm shaft.

Skip this if…

The belt runs on its back, or the pulley needs to transmit motor rotation.

POWGE dimensional drawing

Write a review

Note: HTML is not translated!
Bad Good
Loading the security check…