Menu
Your Cart

POWGE 1.5GT CR open-ended timing belt, 6 mm wide, sold by the metre

POWGE 1.5GT CR open-ended timing belt, 6 mm wide, sold by the metre
POWGE 1.5GT CR open-ended timing belt, 6 mm wide, sold by the metre
POWGE 1.5GT CR open-ended timing belt, 6 mm wide, sold by the metre
New
POWGE 1.5GT CR open-ended timing belt, 6 mm wide, sold by the metre
POWGE 1.5GT CR open-ended timing belt, 6 mm wide, sold by the metre
POWGE 1.5GT CR open-ended timing belt, 6 mm wide, sold by the metre
POWGE 1.5GT CR open-ended timing belt, 6 mm wide, sold by the metre
3.95€
Ex Tax: 3.26€
  • Stock: 45
  • Model: POWGE-15GT-BCR-6
Fast shipping from Spain
Delivery from 24 hours and free shipping available in mainland Spain.
Stock on hand
Shipped quickly from Spain, with a full VAT invoice.
Secure & flexible payment
Pay by card, PayPal or bank transfer.
Expert technical support
Over 10 years helping customers with components and compatibility.

POWGE 1.5GT CR timing belt, 6 mm wide, 1.5 mm pitch. Open-ended, sold by the metre.

Features and dimensions

  • 1.5GT profile, 1.5 mm pitch.
  • Belt width: 6 mm.
  • Open-ended; 1 metre per unit.
  • CR range (chloroprene rubber).
  • Nominal POWGE profile: 1.00 mm overall thickness and 0.56 mm tooth height.

Compatibility and installation

Do not mix belts and toothed pulleys of different pitches. When converting from GT2 to 1.5GT, replace all mating toothed parts, check height, shaft, flanges, routing and anchors, and recalculate travel. Keep a smooth idler only if its running surface and mounting dimensions suit the new setup.

A 1.5 mm pitch allows more teeth for a similar travel per revolution: 21T gives 31.5 mm versus 32 mm for a 16T GT2, and 26T gives 39 mm versus 40 mm for a 20T GT2. It offers a finer tooth spacing when designing or revising the drive. Lower vibration, fewer surface artefacts and greater accuracy are not guaranteed: motor behaviour, stiffness, alignment and tension also matter. At the same linear speed, more teeth pass through the mesh each second. This shifts the excitation frequency: a machine may respond better at some speeds but not others. If surface finish is the goal, compare a test print at several speeds after checking axis travel.

Check alignment and anchors before tensioning. Avoid sharp folds and use the tension specified for your machine.

Supply

Each unit is one metre. Multiple metres are supplied in one continuous length whenever possible.

POWGE offers belts and pulleys in different profiles. Match the pulleys to this belt by profile and width, not by brand alone.

In a 1.5GT belt, adjacent teeth are spaced 1.5 mm apart along the pitch line. The belt can be the same width as a GT2 belt, but its teeth do not mesh with 2 mm pitch pulleys.

Choose this if…

Your axis uses a 6 mm open-ended 1.5GT belt secured at both ends.

Skip this if…

You need to replace a closed-loop belt or retain toothed pulleys of a different pitch.

Write a review

Note: HTML is not translated!
Bad Good
Loading the security check…