New
Out of Stock
ADXL345 V2.0 - Resonance meter - Klipper 3D printers
11.35€
Tax 9.38€
- Stock: Out of Stock
- Model: ADXL345 V2.0
Product out of stock
This product is out of stock, we will try to replenish it as soon as possible. You can request a notice by clicking on the green button (except discontinued products).
Version: 2.0
BIGTREETECH ADXL345 V2.0 is a module for 3D printer resonance compensation. It can communicate through USB, greatly simplifying wiring.
Main features:
- The board has a reserved BOOT button for easey firmware updates.
- Reserved solder points enable users to customize wiring easily.
- The USB port has an added ESD protection chip to prevent the MCU from being damaged by statis electricity through the USB.
Specifications:
- Dimensions: 33.25 x 15.5mm.
- Microprocessor: RP2040 Dual ARM Cortex-M0+ @ 133MH
- Input Voltage: DC 5V.
- Logic Voltage: DC 3.3V.
- Communication with PC: USB2.0.
- Sensor: ADXL345.
- Sensor Communication: 4Line SPI.
- Resolution: Up to 3.9mg/LSB.
- Output Data Rate: 0.1-3200Hz.
- Sensor Operating Temperatura Range: -40ºC to 85ºC.
Firmware Support: currently only supports Klipper firmware.
Flezxible Mounting Options:
- Method 1: StealhBurner Direct Mount.
Effortlessly install ADXL345/S2DW in the desingnated location, streamlining the setup process and saving valuable time. - Method 2: Nozzle Mount.
Remove the original nozzle and install it at the nozzle location to achieve more precise measurements.
Accesories included: screw and silicone rings.
More info here.
0% Customers recommend this product
- 5 Awesome0%
- 4 Great0%
- 3 Average0%
- 2 Bad0%
- 1 Poor0%
Reviews Over ADXL345 V2.0 - Resonance meter - Klipper 3D printers
- (0)
Total Reviews (0)
click here write review to add review for this product.
Report this review.
Tags: boards,
electronic,
bigtreetech