This small servo is commonly used in 3d printers to move small parts that do not need much force as arms for position sensors.- Dimensions approx: 22x11.5x27 mm- Movement speed: 0.12 sec / 60 deg at 4.8 v no load- Torque: 1.2 kg / cm to 4.8 v- Operating voltage: from 3v to 7.2v- Includes 3 arms and ..
Actual Version: 2.1Mini 12864 LCD for an independent printing.Small LCD, but with all the information and features of the popular 12864 LCD, it's easier to install in small 3D printers or where you're looking for a discreet finish.This Full Graphic Smart Controller contains a SD-Card reader, an
rot..
Mini 12864 LCD for an independent printing.Small LCD, but with all the information and features of the popular 12864 LCD, it's easier to install in small 3D printers or where you're looking for a discreet finish.This Full Graphic Smart Controller contains a SD-Card reader, an
rotary encoder and a 1..
MKS 3MOS is a connection fan module. The module integrates 3 MOS control outputs, and its pins and dimensions are compatible with pluggable motor drive slots. It can be used directly by connecting to the drive slot and simply configuring the pin file. Suitable for motherboards with more than 5 axis ..
MKS Eagle is an integrated version of Nano V3.0. Features:Cortex-M4 with FPU 32-bit, 168 MHz. Flash: 512 KB. RAM: 192KB.Compatible with UBS disk printing and TF card printing.Supports Virtual USB Device function.Integrated 5 TMC2209 driver with UART mode.Integrated snap-on drive heat sink and a..
MKS EMMC-8G module and MKS EMMC-Adapter.The EMMC module is more stable and has faster read and write speed than using SD cards.For information about MKS Pi and the configuration click here.For information about MKS SKIPR and the configuration click here...
MKS IPS50 motherboard is a 5 inch capacitive screen. The pixel is 800xRGBx480. It can be connected to MKS SKIPR, MKS Pi board by HDMI and Type C USB interface and also run Klipper screen.It has an integrated DC12-24V power supply interface.Specs:5 inch capacitive screen.Connections: HDMI, TypeC USBP..
MKS Monster8 V2 is an upgraded version of Monster8 V1. On the basis of retaining the functions of the original V1, has added independent DV5V for the Raspberry Pi, has reserved Robin WIFI interface for RRF firmware, added more protection circuits and reserved more functional interfaces.Specs:MCU: ST..
Version: 1.1MKS PI is a high-end microcomputer board designed by Makerbase to replace the Raspberry Pi for the convenience of 3D printing users to use the Klipper firmware. The size, mounting holes, and most interface locations are also compatible with Raspberry Pi 3B. In terms of hardware, MKS PI h..