- Stock: 50
- Model: Silicona-Boquilla-A1-Mini
Model:
A1 Mini
A1
Compatible replacement silicone nozzle wiper for the Bambu Lab A1 Mini. It forms part of the heatbed wiping system and helps remove residue from the hotend tip during automatic preparation before printing.
This is a compatible alternative and not an original Bambu Lab spare part. This listing covers only the approximately 28 × 5.7 mm silicone element; it does not include the metallic wiper, mounting support or printer screws.
Features
- Compatibility: Bambu Lab A1 Mini.
- Approximate dimensions: 28 × 5.7 mm.
- Material: flexible silicone element.
- Function: contacts the nozzle tip during the automatic wiping sequence.
- Installation: on the original support, using the two screws accessed from beneath the heatbed.
- Contents: 1 silicone wiper; the existing support and screws are reused.
Two different wiping elements
The Bambu Lab A1 Mini uses both a metallic wiper and a silicone wiper. This product replaces only the silicone part. If the metallic element is bent, broken or worn, it must be inspected or replaced separately; changing the silicone element does not correct a mechanical fault in the other wiper.
Replace this part when it shows cracks, deformation, missing sections or visible wear, or when residue remains on the nozzle during preparation. Filament stuck to the tip may interfere with bed levelling and first-layer consistency.
Bambu Lab A1 Mini installation
- Switch off and fully unplug the printer. Wait until the nozzle and heatbed are cold.
- Remove the spool and any loose items before tilting the machine.
- Following Bambu Lab's guide, place the printer on its side with the Z-axis pillar facing the table and protect it from scratches.
- Access the underside of the heatbed and remove the two screws holding the silicone wiper with an H1.5 hex key.
- Keep the original screws and support. Compare the replacement with the removed part before fitting it.
- Align the new wiper with the mounting holes and reinstall both screws.
- Tighten only enough to secure it. The screws thread into plastic, and excessive torque may damage the support.
- Return the printer upright, verify its movement and perform bed levelling.
Bambu Lab recommends washing the PEI plate if it was handled or contaminated during maintenance. No firmware changes are required, but observe the first wiping cycle to verify correct nozzle contact with both wiping elements.
Not interchangeable with the A1 version
The A1 Mini part is shorter and uses a different mounting system. The full-size Bambu Lab A1 requires the specific A1 silicone nozzle wiper, approximately 37 × 8 mm with adhesive attachment.
