Stock: In Stock
Model: Spider3-Fysetc-X-Voron
The FYSETC Spider V3.0 F446 is a 32-bit control board designed for 3D printers with many motors and peripherals. It combines a 180 MHz STM32F446, eight replaceable driver sockets, three hotend outputs, one bed output, six fan connectors and an onboard CAN transceiver in a compact 155.3 × 76.5 mm for..
69.99€
Ex Tax:57.84€
Stock: In Stock
Model: TMC2130-SPI-Fysetc
The FYSETC TMC2130 V1.2 is a bipolar stepper motor driver prepared for SPI operation. In addition to STEP and DIR motion signals, firmware can configure current, microsteps and operating mode, read diagnostics and use StallGuard2 when the controller board also routes the required signals correctly.
..
5.50€
Ex Tax:4.55€
Stock: In Stock
Model: TMC2208-Fysetc
The FYSETC TMC2208 V1.2 is a StepStick driver for two-phase bipolar stepper motors, designed to substantially reduce motion noise and provide accurate control in 3D printers, small CNC machines, robots and automation projects. It can operate through standard STEP/DIR signals or use UART to configure..
4.35€
Ex Tax:3.60€
Out of Stock
Stock: Out of Stock
Model: 3DTouch-Fysetc
The Fysetc 3DTouch is a contact probe with a retractable pin, designed to measure the build surface so that the firmware can compensate for height variations during the first layer. Its operating principle is compatible with BLTouch-type probes, although this is a Fysetc product and not a genuine AN..
14.99€
Ex Tax:12.39€
Only a few units in stock
-17 %
Stock: In Stock
Model: Lámina Fysetc MK52
The FYSETC flexible sheet for MK52 magnetic beds is made from spring steel and coated with powder-coated textured PEI on both sides. Its rough surface promotes first-layer adhesion and leaves an even textured finish on the bottom of the printed part.
After printing, the sheet can be removed from ..
34.99€ 28.95€
Ex Tax:23.93€
Out of Stock
Stock: Out of Stock
Model: SBCAN-Fysetc
The FYSETC SB CAN ToolHead V1.3 brings the StealthBurner printhead electronics together on one board. It controls the extruder motor through an integrated TMC2209 driver, the heater and temperature sensor, two fans, RGB lighting, and inputs for a probe or endstop. An onboard ADXL345 supports Klipper..
34.50€
Ex Tax:28.51€
Out of Stock
Stock: Out of Stock
Model: UCAN-Fysetc
The FYSETC UCAN V1.0 connects a host computer over USB-C to a CAN bus used by compatible toolhead boards and other modules. It is based on an STM32F072 and has a pluggable terminal for CAN_H, CAN_L and GND. In a Klipper installation, it provides host communication with CAN nodes; it does not replace..
13.25€
Ex Tax:10.95€