- Stock: 28
- Model: GT2-POWGE-belt-9mm
Model:
6mm Reinforced
6mm Wear Resistant and Reinforced
6mm Reinforced POWGE
6mm Reinforced and Anti vibration and noise RF POWGE
9mm Reinforced POWGE
9mm Reinforced and Anti vibration and noise RF POWGE
9mm Wear Resistant and Reinforced
10mm Wear Resistant and Reinforced
10mm Reinforced POWGE
10mm Reinforced and Anti vibration and noise RF POWGE
POWGE 9 mm GT2 timing belt, made from nylon-covered neoprene and reinforced with internal fiberglass cords.
The 9 mm width is intended for transmissions requiring a larger engagement area than a conventional 6 mm belt, provided that the pulleys, tensioners and clamps have been designed for it.
Features and dimensions
- Brand: POWGE.
- Profile: GT2 / 2GT / 2M.
- Pitch: 2 mm.
- Width: 9 mm.
- Overall thickness: approximately 1.38 mm.
- Tooth height: approximately 0.75 mm.
- Material: nylon-covered neoprene.
- Internal reinforcement: fiberglass.
- Temperature range stated by POWGE for this belt family: approximately −34 to +85 °C.
- Format: open-ended belt.
- Length per unit: 1 metre.
Compatibility
It should be used with GT2 pulleys and tensioners that accept a 9 mm belt. It can be combined with the GT2 16T drive pulley for 9 and 10 mm belts, GT2 20T drive pulley for 9 and 10 mm belts and 9/10 mm GT2 smooth idler, provided that the remaining dimensions match.
Some large-format CoreXY machines and certain RatRig V-Core versions use 9 mm belts. Check the bill of materials for the exact version, as belt length, brand, path and fastening may differ.
It is not directly compatible with the narrow pulleys used by common 6 mm Creality Ender 3, Prusa i3 or Voron configurations.
Comparison with other belts
Compared with the generic wear-resistant 9 mm GT2 belt, this version maintains a POWGE reference within the transmission. For the range intended to reduce noise and vibration, see the 9 mm POWGE GT2 RF belt.
Follow the quality recommended by the machine manufacturer. A generic belt may be sufficient for a basic project, while replacing a specified branded belt with a lower-grade alternative could impair the behaviour of a demanding machine.
Installation
- Do not install the belt on pulleys with only a 6 mm usable width.
- Do not trim its sides to reduce its width.
- Avoid sharp bends that could damage the fiberglass cords.
- Check alignment before applying tension.
- Use clamps designed for 9 mm belts.
Belt width alone does not alter steps per millimetre. Firmware configuration depends on belt pitch, pulley tooth count and transmission ratio.
Supply format
Each unit corresponds to 1 metre of open-ended belt. Multiple units are supplied as one continuous length whenever possible.
Contents: 1 metre of 9 mm POWGE GT2 timing belt.
