- Stock: 944
- Model: HTA3D-V2-Hardware-Set
Hardware set prepared for assembling and servicing the HTA3D V2 extruder. It brings together the M3 and M4 screws, nuts, washers and spring-loaded assembly used throughout the extruder.
It is a convenient way to assemble the printed extruder parts or replace their hardware without sourcing every screw length separately. This is a model-specific kit, not a general-purpose 3D-printer screw assortment.
Kit contents
Screws
- 3 × M3 × 8mm.
- 4 × M3 × 12mm.
- 4 × M3 × 14mm.
- 1 × M3 × 16mm.
- 4 × M3 × 20mm.
- 6 × M3 × 35mm.
- 1 × M3 × 40mm screw with spring and washers.
- 4 × M4 × 25mm.
Nuts
- 4 × M3 nuts.
- 4 × M4 nuts.
Compatibility
The contents are selected for the HTA3D V2 dual-drive extruder and the corresponding HTA3D V2 extruder printed parts.
Individual components may also be useful for repairs or custom projects when the thread, length and mounting arrangement match. The kit should not be considered automatically compatible with every V6, MK8 or dual-drive extruder, as each design may use different quantities and screw lengths.
Not included
- Printed extruder parts.
- Stepper motor.
- Drive gears or pulleys.
- Bearings.
- Hotend, fan or bed-levelling probe.
- Assembly tools.
Assembly recommendations
- Sort the screws by length before starting assembly.
- Refer to the HTA3D V2 extruder assembly to identify the correct position of each component.
- Do not force screws into printed parts or tighten them until the plastic becomes distorted.
- Make sure the spring-loaded assembly can move and apply tension correctly.
- Check fastener tightness after the first few hours of operation.
The finish or colour of individual components may vary between production batches without changing their nominal dimensions or function.
