Compact Internal Corner Bracket for 30 Series Aluminium Profiles, 34 × 34 × 29 mm

Compact internal aluminium bracket for joining 30 series profiles at a 90° angle. It has two fastening points, one on each face, and integrated side reinforcement ribs.

Although its previous name referred to a 3030 profile, it is also compatible with 3060 and other HTA3D profiles belonging to the 30 series. The reference identifies the bracket size rather than exclusive compatibility.

Key features

• Type: compact internal 90° corner bracket.
• Profile family: 30 series.
• Fastening points: 2, one on each face.
• Material: aluminium alloy.
• Colour: grey.
• Approximate dimensions: 34 × 34 × 29 mm.
• Approximate slotted-hole dimensions: 17 × 6 mm.
• Integrated side reinforcement ribs.

Compatibility

Compatible with HTA3D 30 series profiles, including the 3030 aluminium profile and 3060 aluminium profile, as well as other HTA3D profiles and fastening components from this series.

For profiles from other manufacturers, check the slot position and internal channel geometry.

Installation

• Position the bracket inside the corner joint.
• Use one fastening point on each profile.
• Position the profiles at a 90° angle.
• Align the frame before final tightening.
• Check that the joint remains square.

Joint capacity depends on the screws, nuts, tightening and load distribution throughout the frame.

Other versions

For a joint with four fastening points and a larger supporting surface, use the long reinforced internal bracket for 30 series profiles.

Package contents

• 1 × compact internal corner bracket for 30 series profiles.