4-Pin PH2.0 to DuPont NEMA 17 Stepper Motor Cable – 0.5 m

Description

Short four-conductor cable for connecting a stepper motor to a controller board or driver through DuPont-type terminals. It has a 2.0 mm pitch PH-type connector on the motor end.

Its 0.5 metre length is suitable for compact assemblies, test benches and machines where the motor is located close to the electronics.

Key features

• Approximate length: 0.5 m.
• Four conductors.
• Motor connector: 2.0 mm pitch PH type.
• Electronics connection: DuPont type.
• Flexible insulation and metal terminals.
• For four-wire bipolar stepper motors.

Compatibility

Compatible with motors using the corresponding PH2.0 connector and electronics providing suitable pins for DuPont terminals. The motor coil order must be checked before powering the driver.

NEMA 17 describes the motor mounting size, not its electrical connection. Cable colours are also not standardised between manufacturers.

Safe installation

• Switch off the machine before connecting, disconnecting or repositioning terminals.
• Check the motor diagram and driver pinout.
• Verify the coil pairs with a multimeter whenever there is any doubt.
• Ensure that the DuPont terminals cannot move or contact adjacent pins.
• Secure the cable to prevent loads being transferred to the connectors.
• Stop the test if the motor vibrates or fails to rotate smoothly.

Other versions

Also available with a DuPont connection and 1 m length. For electronics using an XH-type connector, see the 0.5 m, 1 m and 2 m versions.

Package contents

• 1 × Four-conductor PH2.0 to DuPont cable, 0.5 m.