4-Pin PH2.0 to XH2.54 NEMA 17 Stepper Motor Cable – 0.5 m

Description

Short four-conductor cable for connecting a stepper motor to a controller board or driver. It has a 2.0 mm pitch PH-type connector for the motor and a four-position XH-type connector for the electronics.

The 0.5 metre length is suitable when the motor is located close to the controller, reducing excess wiring inside compact frames and electronics enclosures.

Key features

• Approximate length: 0.5 m.
• Four conductors.
• Motor connector: 2.0 mm pitch PH type.
• Electronics connector: XH type, commonly described as 2.54 mm pitch.
• Flexible insulation and plastic connectors.
• For four-wire bipolar stepper motors.

Compatibility

Compatibility requires both the connectors and the electrical order of the two motor coils to match. A NEMA 17 motor does not necessarily use a PH2.0 connector or the same pinout.

Each motor coil must reach the correct pair of driver outputs. Wire colours must not be used as the only wiring reference.

Safe installation

• Completely switch off the machine before connecting, disconnecting or repositioning terminals.
• Check the motor and controller diagrams or identify the coils with a multimeter.
• Do not force or offset the connectors relative to their pins.
• Secure the cable with strain relief and keep it away from moving components.
• If the motor does not rotate smoothly, switch off the system and check the wiring before continuing.

Other versions

XH versions are also available in 1 m and 2 m lengths. For DuPont-type connections, see the 0.5 m and 1 m versions after checking the pinout.

Package contents

• 1 × Four-conductor PH2.0 to XH2.54 cable, 0.5 m.