4-Pin PH2.0 to DuPont NEMA 17 Stepper Motor Cable – 1 m

Description

Four-conductor cable for connecting a stepper motor to electronics through a DuPont-type connection. It has a 2.0 mm pitch PH-type connector for the motor and a DuPont connection on the controller or driver end.

The 1 metre length is suitable for 3D printers, prototypes, test benches and electronics projects using controller pins compatible with DuPont connectors.

Key features

• Approximate length: 1 m.
• Four conductors.
• Motor connector: 2.0 mm pitch PH type.
• Electronics connector: DuPont type.
• Flexible insulation and metal terminals.
• For four-wire bipolar stepper motors.

Compatibility

The controller must provide pins physically and electrically compatible with the DuPont connection. The motor connector and coil order must also be checked.

The NEMA 17 designation does not guarantee the same connector or pinout between motors. Do not assume that wire colours correspond to the controller's A+, A−, B+ and B− outputs.

Installation precautions

• Switch off the machine and power supply before connecting or disconnecting the motor.
• Check the controller pinout and motor documentation.
• Use a multimeter to identify which two conductors belong to each coil when reliable documentation is unavailable.
• Check the position of every DuPont terminal before powering the driver.
• Provide strain relief, as this connection may offer less mechanical retention than a locking connector.

Other versions

The DuPont version is also available with a 0.5 m length. For boards using an XH-type connector, see the 0.5 m, 1 m and 2 m versions.

Package contents

• 1 × Four-conductor PH2.0 to DuPont cable, 1 m.