Boards

Version: 1.2Features:Strategic Partnership KLIPPER and BIGTREETECH - The cooperation between KLIPPER and BIGTREETECH makes firmware for 3D printing enthusiasts more convenient to use and helps to further enhance the printing experience.Efficient and Powerful - 64-bit Quad-Core Architecture │ ARM®Cor..

CNC shield V4 board for Nano board.It can be used as a controller expansion board for engraving machines and 3D printers.It has total 3 channel slots for A4988 stepper motor drivers (not included) to control three stepper motors. Each stepper motor channel only needs 2 IO ports, which means 6 IO por..

Version: 2.1MKS DLC32 motherboard kit, is an offline engravinf master control kit developed for desktop engraving machines. The hardware is equipped with a 32-bit high-speed ESP32 module, integrated WIFI function, and directly drives a 3.5-inch touch colour screen; it can realize fast engraving and ..

Logic:Compatible with accessories for Arduino MEGA. Atmega2560 and Atmega32u2 processors are compatible with all RAMPS type firmware.Crystals for USB and processor (sync time at 10ppm).3 thermistor taps + 4th thermistor circuit for ZProbe.Motor controllers:4 Trinamic TMC2130 motor drivers up to 1/25..

Versión: 2.1Features:Integrate 2560 and Ramps 1.4  to one PCB, easier wiring and more stable.Use high quality 4-layer PCB.Use Marlin firmware, same configuration way as Ramps 1.4, it can replace Ramps 1.4 directly.Use special power chip, support 12V and 24V.Support a variety of stepper drivers...