- Stock: Out of Stock
- Model: Kit-Bloque-Kobra3
Replacement assembly for the hotend fitted to the Anycubic Kobra 3 and Kobra 3 Combo. It is supplied assembled with a heater block, heater cartridge, thermistor, bimetal heatbreak, 0.4 mm Brass nozzle and silicone sock.
It is intended to connect to the original Kobra 3 printhead. It should not be treated as a universal hotend or adapted to another machine based on appearance alone.
Features and package contents
- Compatibility: Anycubic Kobra 3 and Kobra 3 Combo.
- Brass nozzle for 1.75 mm filament with a 0.4 mm outlet.
- Bimetal heatbreak.
- Heater block with wired heater cartridge and thermistor.
- Silicone insulating sock and retaining screws.
- Approximate body dimensions: 24 × 23.5 × 15.5 mm.
- Approximate overall length: 98 mm.
- Declared weight: 24.4 g.
Replacement
- Cool the nozzle below 40 °C, switch the printer off and unplug it.
- Remove the printhead front cover and carefully disconnect the black and white leads.
- Release the retaining spring and remove the old hotend.
- Insert the new assembly fully with the white lead facing forwards, then close the retaining spring.
- Reconnect both leads in their original positions, with the black lead at the bottom, and refit the cover.
Monitor the first heating test. If the temperature reading is unstable, a thermal error appears or heating is not controlled normally, switch the machine off and check the connections before continuing.
Conditional compatibility: installation is not guaranteed on the Kobra 3 V2, Kobra S1, Kobra 3 Max or other models that have not been checked with this specific replacement.
