Two-Wire Fan Cable with 2-Pin XH2.54 Connector – 70cm, 1m or 2m

Two-wire cable for powering or extending fans used in 3D printers, CNC machines, electronics enclosures and other projects.

It has a 2-pin XH2.54 connector at one end and two separate crimped contacts at the other. Several lengths are available to suit the cable routing required by each machine.

Main features

• Red and black two-wire cable.
• 2-pin XH2.54 connector at one end.
• Two separate crimped contacts at the opposite end.
• Selectable lengths: 70cm, 1m or 2m.
• Suitable for fans and other simple two-wire devices.
• Contents: 1 cable in the selected length.

Typical applications

• Extending a fan cable to reach the controller board.
• Connecting fans installed in enclosures or electronics boxes.
• Preparing custom wiring for 3D printers and CNC machines.
• Replacing a cable that is too short without modifying the fan.

Compatibility

This cable is intended for two-wire fans using a compatible 2-pin XH2.54 connection. Connector pitch alone does not guarantee compatibility: check the housing shape, contact position and polarity before connection.

The cable does not convert or regulate voltage. The fan receives the voltage supplied by the power source or controller, so the rated voltage of the fan must match the selected output.

For a detachable extension with connectors at both ends, consider the GDSTIME 1m male-to-female 2-pin XH2.54 extension cable. To connect two fans to a single output, consider the 2-pin XH Y-splitter cable for two fans.

Safe installation

• The red wire is normally positive and the black wire negative, but polarity must be verified before powering the fan.
• The separate contacts must be fitted into a compatible housing or connected using a suitable system for the selected electronics.
• Conductive contacts must not be left exposed, as this could cause a short circuit.
• Ensure that the output can provide the current required by the fan.
• Secure the cable so that machine movement cannot pull on the contacts.