M4 Hammer T-Nut for 20 Series Aluminium Profile, 6 mm Slot

M4 hammer T-nut for fastening components to 20 series aluminium profiles with a 6 mm slot. It can be inserted directly through the open slot, allowing accessories to be added or repositioned without accessing the ends of the frame.

After insertion, the nut is turned approximately 90° so that its body sits across the inside of the profile.

Key features

• Type: hammer nut or T-nut.
• Thread: M4.
• Profile family: 20 series.
• Nominal slot width: 6 mm.
• Nominal length: 10.3 mm.
• Nominal height: 5 mm.
• Approximate weight: 0.97 g.

Compatibility

Compatible with HTA3D 20 series aluminium profiles, including the 2020 profile and 2040 profile, as well as HTA3D accessories from the same profile family.

For profiles from other manufacturers, both the nominal 6 mm slot width and the internal channel geometry should be checked.

Installation

• Insert the nut directly through the slot.
• Turn it approximately 90° until positioned across the channel.
• Position the accessory and tighten the M4 screw.
• Check that the nut has rotated and seated correctly before final tightening.

Select the screw length according to the thickness of the mounted component. Avoid using a screw that bottoms out before the joint is fully tightened.

Alternative mounting option

For assemblies where the fastener can be inserted from the end of the profile, the M4 sliding T-nut for 20 series profiles is available.

Package contents

• 1 × M4 hammer T-nut for 20 series profile.